Connect the Camera Trigger

The 61S camera does not have relay trigger for the camera multi-cable.

Please note 42L does not have Relay-to-PWM module, the Factory default triggering method is PWM, unless user contact ADTi tech support service before purchasing. It is either Relay (TTL) or PWM trigger, but it can be changed from PWM to TTL by flashing the camera firmware (please read [How to Flashing ADTi camera firmware] section to see the details).

Please note: disconnecting the camera power supply will NOT save the new settings, use ON/OFF ON/OFF button on the touch screen OR serial port from PC or bluetooth (please see [How to use ADTi serial port] via PC solution and [How to use ADTi blue tooth] sections) to save the camera new settings .

Please check Portal [ADTI PX4 or Ardupilot Setup]for triggering camera by autopilot.